Wagner Power Painter II Manuel d'utilisateur télécharger pdf (Page 9)

English

Title

Spraying Technique

1. Keep your arm moving at constant speed and keep the

sprayer at a constant distance from the surface. The

sprayer should be triggered at the beginning of the

stroke and released at the end of the stroke.

2. Keep the sprayer at right angles to the surface. This

means moving your entire arm back and forth rather

than just exing your wrist.

Never tip the sprayer at more than a 45º angle

when spraying overhead. Material could get into

the motor housing and cause an electric shock.

IMPORTANT: If material is leaking from the threads of the

spray tip, turn off the sprayer immediately or the sprayer

could be damaged. The sprayer will leak from behind the

spray tip if the atomizer valve is not seated properly. If

you notice material leaking from this area:

Keep stroke

even

End

stroke

Start

stroke

Pull

trigger

Release

trigger

Move steadily

Aproximately

10 to 14 inches

Heavy Coat

Do not flex

wrist while

spraying.

Light Coat Light Coat

3. Unplug the sprayer immediately. Remove the spray tip

by turning it counterclockwise.

5. Put the atomizer valve back in place, making sure it can

seat properly without any obstruction.

4. Remove the atomizer valve and see if it needs to be

cleaned or replaced (see page 15). Also check the

pump housing opening for any dirt or other obstruction

and clean if necessary.

6. Thread on the spray tip by turning it clockwise and

tighten rmly by hand.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Commentaires sur ces manuels

Pas de commentaire

Wagner Power Painter II Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Wagner Power Painter II