WAGNER FORCE TEN Spécifications télécharger pdf (Page 10)

FORCE TEN

™

FDX FORCE GAGE

FORCE TEN

™

FDX FORCE GAGE

CALIBRATION IMPLEMENTS

F. Implements

Several implements are available for use with the FDX - see Table 2. A hook and

at implement are included with FDX. All implements are attached to the American

Standard 10-32 FDX load shaft thread. Metric thread adapters are available.

F.1 Attaching the FDX Hook and Flat Implement

Calibrate:

• Apply full-scale weight matching the display - in lbf.

• Push SELECT with weight applied and movement stopped.

• FDX displays applied weight indicating successful calibration.

FDX will reject a calibration with weights that are higher or lower than FDX

full-scale capacity. It is possible for FDX to accept a calibration with weights

that are close to, but do not match the full scale capacity of FDX. This

erroneous calibration will give inaccurate readings.

Calibration Accepted

• FDX displays the actual applied weight indicating successful calibration. If

uuuuu (under) or nnnnn (over) is displayed the weight is not accepted, or other

problems exist - see Calibration Rejected (below).

 Vericationisrecommendedbyapplyingweightstocheckaccuracyat

various points of FDX range.

• To exit calibration, push SELECT when FDX full-scale capacity is displayed or at

anytime during or after the ve point weight test.

• FDX ashes donE and returns to normal operation.

• Auto-Calibration is complete and FDX is ready for use.

Calibration Rejected

• If the weight is not accepted, the display shows uuuuu (under) or nnnnn (over).

Verify weight applied matches the FDX capacity.

• If the weight used does not match FDX capacity, repeat E.3.1 Auto-Calibration

with an accurate full scale weight.

• If uuuuu or nnnnn is displayed again after repeating Auto-Calibration, the FDX

may be defective or damaged. Call Wagner Instruments for instructions.

1 2 ... 5 6 7 8 9 10 11

Pas de commentaire

WAGNER FORCE TEN Spécifications Page 10