WAGNER 9190 Manuel du propriétaire télécharger pdf (Page 11)

English

Spraying Troubleshooting - Unclogging the Spray Tip

NOTE - Do not use a needle or other sharp pointed instrument to clean the tip. The hard tungsten carbide can chip.

If the spray pattern becomes distorted or stops completely while the gun is triggered, follow these steps.

1. Release the trigger and lock the gun off (see page 7).

Rotate the reversible tip arrow 180º so that the point of

the arrow is toward the rear of the gun (CLEAN position).

Under pressure, the spray tip may be very difficult to

turn. Turn the PRIME/SPRAY knob to PRIME and

trigger the gun. This will relieve pressure and the tip

will turn more easily.

2. Turn the PRIME/SPRAY knob to SPRAY.

3. Unlock the gun and squeeze the trigger, pointing the gun

at a scrap piece of wood or cardboard. This allows

pressure in the spray hose to blow out the obstruction.

When the nozzle is clean, material will come out in a

straight, high pressure stream.

If material still will not spray from the spray tip, follow

the Cleaning the spray gun filter instructions, page 12.

4. Release the trigger and lock the gun off (see page 7).

Reverse the tip so the arrow points forward again (SPRAY

position). Unlock the gun and resume spraying.

GX-05 / GX-07

GX-08

Gun locked

(see page 7)

SPRAY

PRIME

GX-08

GX-05 / GX-07

Gun locked

(see page 7)

Do not attempt to unclog or clean the tip with your finger.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Pas de commentaire

WAGNER 9190 Manuel du propriétaire Page 11