WAGNER CONTROL SPRAY Manuel du propriétaire télécharger pdf (Page 11)

Maxum I HVLP Spray Gun Adjustments

Air Control Valve

Material Flow

Adjustment

External Packing Nut

One-Way Valve

To produce the highest-quality finish possible, the spray gun requires the

proper air and material adjustments. You control the air flow with the air

control valve, located at the rear of the gun.

Note the notch that is cast into the control knob on the valve. Air flow is at its

fullest when the knob is set at the 12:00 position. Rotating the valve 180° either

direction cuts off the air.

The air control valve is used when spraying with light viscosity materials or

in confined areas, such as cabinets or lockers. When spraying light material,

full air is not needed. Restrict the valve until you achieve proper atomization

without excess overspray.

The amount of paint fed

from the cup out the nozzle

is controlled by the material

adjustment knob located at

the heel of the gun, just above

the handle. To decrease paint

flow, turn the fluid

adjustment knob clockwise.

To increase the paint flow,

turn the knob

counter-clockwise. A little

experimentation will give

you the correct combination

of paint and air necessary

to achieve the desired finish

and fan size. The material

adjustment can also be used to set a specific trigger pull, so the same pattern

size and material flow are consistently obtained on each pass.

The external packing nut, located directly in front of the trigger, is used to

adjust the packing so a seal is maintained around the needle.

The one-way valve, or

serviceable check valve, is

designed to allow air into the

cup, putting the material under

pressure, yet not releasing the

cup pressure. CAPspray‘s

one-way valve prevents paint

from seeping up the air tube

into the air passages of the gun.

It also eliminates any delay in

material flow when the gun

is triggered.

CAPspray‘s one-way valve is

easily detached for cleaning purposes. The valve simply rotates to open for

cleaning and contains a disk that can be removed and cleaned with soap and

water for waterborne materials or a compatible solvent for other materials.

MAX

Maximum Air Flow

Minimum

Air Flow

Minimum

Air Flow

Material flow

Air control

Packing Nut

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

WAGNER CONTROL SPRAY Manuel du propriétaire Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Pulvérisateur de peinture WAGNER CONTROL SPRAY