WAGNER CONTROL SPRAY Manuel du propriétaire télécharger pdf (Page 18)

Cleaning Your Equipment

Spray Gun

Filter

It is important to clean your spray gun thoroughly after each use.

1. Empty the spray material from cup.

2. Pour a small amount of the appropriate solvent in the cup and attach the cup to

the spray gun.

3. Shake and spray the gun in a well-ventilated area. Back-flushing of the system

is not necessary, so do not restrict the nozzle when cleaning.

4. Repeat the steps above until the solvent appears clear.

5. Wipe the exterior of the cup and the spray gun with the appropriate solvent

until it is clean.

6. Make sure the air holes and material passages are completely clean.

Never use metal tools or picks to clean the air cap or nozzle.

7. Thoroughly clean the check valve and hoses. Do not soak check valve hoses in

hot solvents. Failure to clean check valve will result in problems the next time

you use the gun.

It is a good idea to lubricate any threaded parts on

the sprayer with petroleum jelly when you put them

back together. This helps keep them working

properly. However, do not use any lubricants

containing silicone, which can cause problems when

used with some paints.

The cup gasket must be replaced periodically due to

normal wear. It is important to inspect the gasket

during each cleaning.

If material leaks from around or through the packing

nut, tighten the packing nut slightly. Squeeze the

trigger to see if the leaking has stopped. If it has not,

continue to tighten the packing nut until the leaking

stops. Be careful not to over-tighten the packing nut

or the needle will stick in the packing. If adjusting the packing nut does not stop

the leak, replace the packing.

1. Remove the filter as shown.

2. Use air to blow material residue from the filter,

or tap the particles out. For material that is not

easily blown or knocked loose, try soapy water

or mineral spirits. Allow filter to dry before

placing back in unit. Filters should not be

cleaned with highly flammable solvents. If the

filter does not come clean using these methods,

install a new filter.

3. Once the filter is cleaned, insert it back into the

end from which it was removed. Note that the

two-stage filter found on the gun atomizing air

chamber needs to go in with the green side on the inside.

Cup

Gasket

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

WAGNER CONTROL SPRAY Manuel du propriétaire Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Pulvérisateur de peinture WAGNER CONTROL SPRAY