WAGNER CONTROL SPRAY Manuel du propriétaire télécharger pdf (Page 5)

English

ON/OFF SWITCH

ADJUST SPRAY PATTERN

NEVER

trigger the gun while adjusting the ears on the air cap.

NEVER point the spray gun at any part of the body.

MATERIAL FLOW ADJUSTMENT

Set the material volume by turning the regulator on the

rear part of the gun spray gun. A scale on the regulator

serves as a guide.

WARNING

Nut

Air cap

Round pattern

Horizontal pattern

Vertical pattern

The spray pattern shape is adjusted by turning the ears of

the air cap to either the vertical, horizontal, or diagonal

positions. The positions of the air cap and the

corresponding spray pattern shapes are illustrated below.

Test each pattern and use whichever pattern is suitable for

your application.

The ON/OFF

switch is located underneath the end of the

carrying handle on the turbine as shown below

PROPER SPRAYING TECHNIQUE

SURFACE PREPARATION

All objects to be sprayed should be thoroughly cleaned before

spraying material on them.

Areas not to be sprayed may, in

certain cases, need to be masked.

SPRAY AREA PREPARATION

When spraying indoors, the spray area must be clean and free of

dust in order to avoid blowing dust onto your freshly sprayed

surface.

HOW TO SPRAY PROPERLY

• Position the spray gun perpendicular to and one (1) or more

inches from the spray surface, depending upon the spray

pattern size desired.

• Spray parallel to the surface with smooth passes at a

consistent speed as illustrated below. Doing this will help

avoid irregularities in the finish (i. e. runs and sags).

• Always apply a thin coat of material on the first pass and

allow to dry before applying a second, slightly heavier coat.

• When spraying, always trigger the spray gun after spray pass

has begun and release trigger before stopping the pass. The

best results occur when making 20-inch passes. Always keep

the gun pointed squarely at the spray surface and overlap

passes slightly to obtain the most consistent and professional

finish possible.

When you quit spraying for any length of time, turn the

turbine OFF and place the spray gun into the spray gun

holder on the turbine.

Incorrect

Do not flex wrist while spraying.

Light coat Heavy coat Light coat

1 to 12 inches

Correct

Even coat throughout

Keep stroke smooth and at an even speed

If spraying with an HVLP

spray system is new or unfamiliar

to you, it is advisable to practice on a piece of scrap wood

or cardboard before beginning on your intended workpiece.

SPRAYING

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

WAGNER CONTROL SPRAY Manuel du propriétaire Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de pulvérisation fine de puissance WAGNER CONTROL SPRAY